Description

Once diluted our Snow Foam is safe for all ceramic, wax and sealant based coatings. Use it to reduce the risk of swirl marks

Instructions

1. Remember to always test the product on an inconspicuous area first. Fill up approximately 100ml of snow foam into Sam’s foam lance bottle and top off with warm water.

2. Foam the entire vehicle including the wheel arches and allow to dwell for approximately 10 minutes depending on the temperature.

3. Thoroughly rinse off the vehicle and begin your wash stage.

FAQ

What scent is Snow Foam?

Apple scented.

Is Snow Foam pH neutral?

When diluted, Snow Foam is pH neutral. Used neat, it is slightly alkaline.

My foam isn't very thick, what should I do?

Try decreasing the dilution and adjusting your pressure washer. In hard water areas, the foam may be a little less thick. Also don't apply onto a wet car as this will dilute the foam as you apply.

Which direction should I apply Snow Foam?

Spray from bottom to top to allow the foam to sit on the dirtier areas for longer. When rinsing however, spray top to bottom to ensure the foam doesn't drip onto clean areas.

Can I use Snow Foam on my motorbike?

Yes Snow Foam is suitable for motorbikes.

PRE-WASH